This sensor can be used to guide Automated Guided Vehicle (AGV) without problem under environment where machining oil, dust, or lint is suspended in the air, or on a carpet . Three types of sensors are available: Guide sensor for guiding AGV to run along a magnetic tape (guide tape), Address sensor for obtaining the location information of AGV, and Stop sensor for detecting stop location. Also available are magnetic tapes (guide tape) attached on floors and magnetic rods.
Guiding automated guided vehicles (AGV), obtaining information on locations (relative address), and obtaining information on stop locations.
* Sensor for guiding automated guided vehicles to destination points
* Digital 8 bit output (10 mm pitch)
* NA unique circuit design, realizing low cost
* RoHS compliant
* Japan made
NPN open collector
Normally open 8 points
40 mm or more
Standard control magnet50 mm wide x 0.8 mm thick
Rubber magnet (sold separately)
Guiding AGV route
Operating temperature-10 to +50°C
Electrical characteristics Operation voltage12 to 24 VDC
Maximum current consumption50 mA(at DC 12V)
Maximum residual voltage0.6 V
Maximum switching current50 mA(at DC 12V)
Others Ingress protection-
External drawing
* Guide tape (magnetic tape)
* 50 mm wide x 25,000 mm long x 1 mm thick
* Japan made
